Setting High-Speed Printing - Hitachi RX Technical Manual

Setting high-speed printing (Optional on RX-S)
(1) Overview
● When the character size setting is 5 x 7 or 5 x 8 dots, and print line is set to 2 or 3 lines, three modes of HM,
NM or QM can be selected.
By selecting the mode, high quality printing result can be ensured according to the line speed.
HM mode
1 Necessary conditions to perform high-speed print
● When all necessary conditions from Nos. 1 to 7 are satisfied, high-speed print HM, NM or QM
mode can be selected.
Type of high-speed print and number of vertical dots used
2
● Number of vertical dots used in high-speed print is shown in Table below.
● When calculating printing preparation time, etc., pay attention to number of vertical dots.
Ink drop use rate Type
1/1
1/2
(Note) * When 2-line printing is set, setting of NM ans QM will be the same.
9-4 ●Setting high-speed print (Optional on RX-S)
No. Item
1 Character size
2 Print line
3 Line spacing
4 Barcode
5 Character orientation
6 Ink drop use percentage Ink drop use percentage: 1/1
Print specifications
Message name [ ]
2nd screen
1st screen
Character height
Ink drop use
High-speed print
Character width
Character
0:ＡＢＣ 1:ＡＢＣ
orientation
→ ←
Printing method 2（１：Single scan ２：Interlaced ３：Mixed）
Print start
delay
Sensor
Print start delay ００００
（0∼9999）SC
Number of vertical dots used in the nozzle diameter is 65μm
Number of vertical dots used in 2-line Number of vertical dots used in 3-line
Character size 5x7 Character size 5x8 Character size 5x7 Character size 5x8
HM 14
NM 21*
QM 21*
- 28
NM mode
Condition of nozzle diameter is 65μm
Character size is 5 x 7 or 5 x 8 for all printing items.
Number of lines is 2 or 3 in all columns.
Line spacing is equal in all columns.
No barcode is set for any print items.
Set value of character orientation is 0 or 1.
[Stop ]
3rd screen
９０
（0∼99）
０１
（1/1∼1/16）
HM NM QM
０００２ （0∼3999）
Arrow : Prin-
3:
2:
← →
ting direction
Print start
16
24*
24*
32
Remarks
HM mode is equivalent to particle use
percentage of 1/1.
In the 2-line print setting, NM mode is
equivalent to ink drop use percentage
of 1/1.5.
If the line speed remains the same,
print width in the NM mode will widen
by 1.5 times with respect to HM mode.
2015.07.07 12:45
Com=0
M
Startup
Manual
HOME
High-speed print
Edit
message
Print
format
Change unit
Back
21
28
35
42
24
32
40
48