Print Head Cleaning - Hitachi PXR-D Instruction Manual

1.2.3 Print head cleaning

Do not pour the
makeup ink over
this section.
Wipe the print head clean with
wiping paper dampened with the
makeup ink.
When a print error or
emergency stop
occurs, refer to 8. "If a
Warning Condition/
Fault Occurs".
Regarding cleaning at
a shutdown, refer to 2.2
"Shutdown".
The stain due to ink
splashes can be
removed effectively by
performing air purge for
the print head. Refer to
1.2.6 "Print head air
purge".
1
Cleaning with the makeup ink should be limited to the end of the print head.
To clean the end of the print head with the makeup ink, orient the end of the
print head downward.
2 Never immerse the print head in the makeup ink.
3 After cleaning, thoroughly wipe the print head with wiping paper and allow
it to dry.
¡It is necessary to wipe and dry the nozzle, charging electrode, deflecting
electrode, mounting base and fringe of the gutter.
¡While the print head is wet, do not orient its end upward.
¡If you use the JP-K60, JP-F63,JP-K68, JP-E78 ink,you must allow the
printhead to dry firmly before running because the ink is not easy to dry.
Do not pour the
makeup ink over
this section.
Cleaning range
Charging
electrode
Nozzle
Deflecting
electrode
Gutter
Usage Precautions 1-9