Setting High-Speed Printing; Overview; When Performing High-Speed Printing By 1 To 3 Lines. (Nozzle Diameter : 65Μm) - Hitachi UX2 Technical Manual

8.2. Setting high-speed printing

8.2.1. Overview

● Six modes of HM, NM, QM, SM, D1 or D3 can be selected.
By selecting the mode, high quality printing result can be ensured according to the line speed.
HM mode
● References for each nozzle diameter
Nozzle diameter
65μm
8.2.2. When performing high-speed printing by 1 to 3 lines. (Nozzle diameter : 65μm)
①Necessary conditions to perform high-speed print
● When all necessary conditions from Nos. 1 to 7 are satisfied, high-speed print HM, NM, QM, SM, D1 or
D3 mode can be selected.
No. Item
1 Print line
2 Character size
3 Line spacing
4 Barcode
5 Character orientation
6 Ink drop use rate
7 Ink drop charge rule
* If high-speed print mode is "D1" or "D3", it is better to select same Inter-character space setting for
keeping better print quality.
NM mode
Refer to (8.2.2.) and (8.2.3.) below in this section.
Number of lines of all columns is the same.
(Refer to Table in " Type of high-speed print and number of vertical dots
used" for number of print lines available.)
Character size of all print items is the same.
(Refer to Table in " Type of high-speed print and number of vertical dots
used" for character sizes available.)
Line spacing of all columns is the same. However, if Line spacing is set to 3
or more, High-speed printing is NOT available.
NOT available.
0 or 1.
1/1
Standard (Single scan or interlaced)
Remarks
HM mode is equivalent to particle use
percentage of 1/1.
In the 2-line print setting, NM mode is
equivalent to ink drop use percentage
of 1/1.5.
If the line speed remains the same,
print width in the NM mode will widen
by 1.5 times with respect to HM mode.
References
Conditions
157