Ink Replacement - Hitachi PXR-D Instruction Manual

7.5 Ink Replacement

(1) Overview
¡This procedure is performed when replacing old ink with new one.
¡The procedure cannot be performed during ink ejection.
Initiate the procedure while the printer is in the "Stop" state.
¡Before charging new JP-Y37 ink, shake the ink bottle well until the
precipitated pigment has been dispersed. Also make sure that there is no
sedimentation in ink reservoir or main ink tank (see "Usage Precautions" on
page 1-6).
* Replace the ink filter and circulation filter at the same time when replacing
the ink so as not to waste the ink.
(2) Operating procedure
1
Open the "Circulation control" screen, and sequentially press the
Ink replacement key and Start/Continue key.
Circulation control
Eject ink
(Goes to standby)
Nozzle backwash
Ink replacement
Process prior to
long-term shutdown
Select option; press [Start/Cont.]
2
The operating guidance on the ink replacement appears on the
display.
Follow the on-screen instructions.
Circulation control
Function Ink replacement
Operating guide
Disconnect the recovery tube
and put the end in a beaker.
Press [Start/Continue].
Proc. time: Approx. 4 minutes.
2011.07.07 12:45 Status: Stop
Cleaning stop No-cleaning stop
Gutter cleaning
Ink filter
Ink circulation
replacement
Process after
Makeup ink refill
long-term shutdown
Proc. status:
Status:Service
2011.07.07 12:45
Proc. status:
Prev. Next
menu menu
Cancel
Start/
Continue
Ink drainage
Ink rep.
Ink refill
Abort
Start/
Continue
Ink Replacement 7-8