Shutdown (No-Cleaning Stop) - Hitachi PXR-D Instruction Manual

1.2.4 Shutdown (no-cleaning stop)

When you press the Shut down key on the upper right-hand corner of a
screen, the printer stops after completing its automatic nozzle cleaning
sequence. If you repeatedly activate the Shut down key to stop an operation,
excessive makeup ink enters the printer, thereby thinning the ink or producing
an unduly high ink main tank solution level. If it is absolutely necessary to
repeatedly stop a printer operation, use the following procedure.
The procedure below works even while the startup sequence is being executed
(the Shut down key is inoperative during the startup sequence).
1 Press the Manual key (the Manual key is displayed commonly on all
screens).
Status:Ready
Press the No-cleaning stop key within the control menu.
2
Eject ink: Ejects ink while applying no deflection voltage.
No-cleaning stop: Stops ink ejection without cleaning.
Standby
Eject ink
The ink stop confirmation message appears.
3 Press OK .
Solution
OK
*1: Do not use the Shut down key to stop an operation more than two
successive times.
*2: If you stop an operation with the No-cleaning stop key, immediately
initiate ink ejection. If such a condition is allowed to continue, the
nozzle may become stuck with the ink, causing the ink beam to be
bent or the nozzle to be clogged.
Accordingly, apply the makeup ink to the orifice plate to wash it within
30 minutes after a stop, and then cause ink to eject once again.
Com=0
Start Shut
up down
Comm
Manual
On/Off
Manual key
Manual Control Menu
: Switches between the ready - for - printing state
and standby state.
No-cleaning
Standby
stop
Shut down Process Confirmation
Shutdown will stop the ink jet.
To stop the ink jet, press [OK].
Common to all screens
Cancel
Cancel
Usage Precautions 1-11