Answering A Call Via The Loudspeaker; (Speakerphone Mode); Switching To Speakerphone Mode - Siemens HiPath 2000 Operating Instructions Manual

Step by Step
Answer
+
if nec.
+
if nec.
+
if nec.

Answering a call via the loudspeaker

(speakerphone mode)

Suggestions for using speakerphone mode
• Tell the other party that you are using speakerphone
mode.
• The speakerphone works bests at a low receiving
volume.
• The ideal distance between the user and the tele-
phone set in speakerphone mode is about 50 cm
(approx. 20 inches).
The phone is ringing. The caller appears on the screen.
Pay attention to the notes on voice encryption
page 78.
n
Press the key shown. The LED lights up.
or
Confirm.
The speakerphone function is activated.
-
or
Set the call volume. Keep pressing the key until the de-
sired volume is set.
Ending a call
n
Press the key shown. The LED goes out.
or
s
Press the key shown.

Switching to speakerphone mode

Prerequisite: You are conducting a call via the handset.
n \
Hold down the key and replace the handset. Then re-
lease the key.
-
or
Set the call volume. Keep pressing the key until the de-
sired volume is set.
U.S. mode
If the country setting is set to U.S. (ask the service per-
sonnel), you do not have to hold down the loudspeaker
key when replacing the handset to switch to speaker-
phone mode.
n
Press the key shown.
]
Replace the handset. Proceed with your call.
-
or
Set the call volume. Keep pressing the key until the de-
sired volume is set.
Basic functions
31