Basic Functions; Answering A Call; Answering A Call Via The Handset - Siemens HiPath 2000 Operating Instructions Manual

Basic functions

Step by Step
+
if nec.
30
Basic functions
Please read the introductory chapter "Getting to
know your OpenStage phone"
fully before performing any of the steps de-
scribed here on your phone.

Answering a call

Your OpenStage phone rings with the tone signal set
when an incoming call is received. The call is also visu-
ally signaled on the call display.
• When you receive an internal call, your telephone
rings once every four seconds (single-tone se-
quence).
• When you receive an external call, your telephone
rings twice in rapid succession every four seconds
(dual-tone sequence).
• When you receive a call from the entrance tele-
phone, your telephone rings three times in rapid
succession every four seconds (triple-tone se-
quence).
• If a call is waiting, you hear a short tone (beep) every
six seconds.
Your service personnel can adjust the ring ca-
dence for external and internal calls for you.
In other words, different ring cadences can be
set for different internal callers.
If transmitted, calling party information (name, phone
number) appears on the graphic display.
An incoming call will interrupt any ongoing tele-
phone setting operations.

Answering a call via the handset

The phone is ringing. The caller appears on the screen.
Pay attention to the notes on voice encryption
page 78.
^
Lift the handset.
-
or
Set the call volume. Keep pressing the key until the de-
sired volume is set.
page 13 care-