Cli: Configuring And Displaying Trap Receivers; Using The Cli To List Current Snmp Trap Receivers - SMC Networks SMC6624M Management Manual

Configuring for Network Management Applications
Trap Receivers and Authentication Traps

CLI: Configuring and Displaying Trap Receivers

Trap Receiver Commands Used in This Section
show snmp-server
snmp-server host
snmp-server enable traps authentication

Using the CLI To List Current SNMP Trap Receivers

This command lists the currently configured trap receivers and the setting for
authentication traps (along with the current SNMP community name data —
see "SNMP Communities" on page 8-5).
Syntax:
In the next example, the show snmp-server command shows that the switch
has been previously configured to send SNMP traps to management stations
belonging to the "public," "red-team," and "blue-team" communities.
SMC6624M(config)# show snmp-server
Example of
Community
Name Data (See
page 8-5.)
Example of Trap
Receiver Data
Figure 8-4. Example of Show SNMP-Server Listing
8-10
<ip-addr> <community-name>
[none | all | non-info| critical | debug]
show snmp-server
SNMP Communities
Community Name MIB View Write Access
---------------- -------- ------------
public Operator Restricted
blue-team Manager
red-team Manager
Trap Receivers
Send Authentication Traps : No
Address Community
---------------------- ---------------- -------------------
13.28.227.200 public
13.28.227.105 red-team
13.28.227.120 blue-team
below
page 8-11
page 8-11
Unrestricted
Unrestricted
Events Sent in Trap
All
Critical
Not-INFO
Authentication
Trap Setting