Cli: Viewing And Configuring Sntp - SMC Networks SMC6624M Management Manual

Configuring IP Addressing, Time Synchronization, Interface Access, and System Information

CLI: Viewing and Configuring SNTP

CLI Commands Described in this Section
show sntp
[no] timesync
sntp broadcast
sntp unicast
sntp server
Protocol Version
poll-interval
no sntp
This section describes how to use the CLI to view, enable, and configure SNTP
parameters.
Viewing the Current SNTP Configuration.
This command lists both the time synchronization method (TimeP, SNTP, or
None) and the SNTP configuration, even if SNTP is not the selected time
protocol.
show sntp
Syntax:
For example, if you configured the switch with SNTP as the time synchroni-
zation method, then enabled SNTP in broadcast mode with the default poll
interval, show sntp lists the following:
SMC6624M# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Broadcast
Poll Interval (sec) [720] : 720
Figure 3. Example of SNTP Configuration When SNTP Is the Selected Time
Synchronization Method
In the factory-default configuration (where TimeP is the selected time syn-
chronization method ), show sntp still lists the SNTP configuration even though
it is not currently in use. For example:
Time Synchronization Protocol Options
page 5-19
pages 5-20 and ff., 5-23
page 5-20
page 5-21
pages 5-21 and ff.
page 5-23
page 5-23
page 5-24
5-19