Using The Cli To View Stack Status - SMC Networks SMC6624M Management Manual

Using the CLI To View Stack Status

You can list the stack status for an individual switch and for other switches
that have been discovered in the same subnet.
Syntax: show stack [candidates | view | all]
Viewing the Status of an Individual Switch. The following example
illustrates how to use the CLI in an SMC6624M to display the stack status for
that switch. In this case, the switch is in the default stacking configuration.
Syntax: show stack
Big_Waters-0(config)# show stack
Stacking - Stacking Status (This Switch)
Stack State : Commander
Transmission Interval : 60
Stack Name : Big_Waters
Auto Grab : No
SN MAC Address System Name
-- ------------- ---------------- ----------- -------------------------
0 0001e7-c04100 Big_Waters-0
Figure 9-22. Example of Using the Show Stack Command To List the Stacking
Configuration for an Individual Switch
Viewing the Status of Candidates the Commander Has Detected.
This example illustrates how to list stack candidates the Commander has
discovered in the ip subnet (broadcast domain).
show stack candidates
Syntax:
Big_Waters-0(config)# show stack candidates
Stack Candidates
Candidate MAC System Name
------------- ------------------------- -----------
0060b0-889e00 DEFAULT_CONFIG
Figure 9-23. Example of Using the Show Stack Candidates Command To List
Candidates
Configuring Advanced Features
Number of members
Members unreachable
Device Type Status
SMC 10/100 Commander Up
Device Type
SMC 10/100
Stack Management
: 0
: 0
9-31