Cli: Configuring Ip Address, Gateway, And Time-To-Live (Ttl) - SMC Networks SMC6624M Management Manual

Configuring IP Addressing, Time Synchronization, Interface Access, and System Information
IP Configuration
6.
7.
8.
CLI: Configuring IP Address, Gateway, and Time-To-
Live (TTL)
IP Commands Used in This Section
Viewing the Current IP Configuration. The following command displays
the IP addressing for each VLAN configured in the switch. If only the
DEFAULT_VLAN exists, then its IP configuration applies to all ports in the
switch. Where multiple VLANs are configured, the IP addressing is listed per
VLAN. The display includes switch-wide packet time-to-live, and (if config-
ured) the switch's default gateway and Timep configuration.
Syntax: show ip
For example, in the factory-default configuration (no IP addressing assigned),
the switch's IP addressing appears as:
SMC6624M# show ip
The Default IP
Configuration on
the SMC6624M
Figure 5-2. Example of the Switch's Default IP Addressing
5-6
• If you want to manually configure the IP information, use the Space
bar to select Manual and use the [Tab] key to move to the other IP
configuration fields.
Select the IP Address field and enter the IP address for the switch.
Select the Subnet Mask field and enter the subnet mask for the IP address.
Press [Enter], then [S] (for Save).
show ip
vlan <vlan-id> ip
address
ip default-gateway
ip ttl
Internet (IP) Service
Default Gateway :
Default TTL : 64
VLAN | IP Config
------------ + ---------- --------------- ---------------
DEFAULT_VLAN | DHCP/Bootp
page 5-6
page 5-7
page 5-8
page 5-8
IP Address Subnet Mask