Adjusting the Machine
This section describes how you can make fine adjustments to the settings of the
machine, such as making a fine adjustment to the printed image and the page
number or watermark position.
It is recommended that you perform an Automatic Gradation Adjustment and clean
the machine regularly.
Zoom Fine Adjustment
4
When you print a copy or a document from an inbox, a slight difference in size may
occur between the size of the original image, and the size of the copied/printed
image. In this case, you can perform a fine adjustment to compensate for this
difference.
1
2
Saddle Stitch Staple Repositioning
You can reposition the stapler of the saddle stitcher unit after clearing a staple jam,
or after replacing the staple cartridge. Saddle stitch staple repositioning works by
feeding several sheets of paper into the saddle stitcher unit and stapling them
together.
CAUTION
If transparencies are loaded in a paper drawer, make sure to pull out that paper
drawer slightly so that transparencies are not fed for the saddle stitch staple
repositioning procedure. Damage to the machine may occur if transparencies
are fed during this procedure.
4-66
Adjusting the Machine
(Additional Functions) ➞ [Adjustment/Cleaning] ➞
Press
[Zoom Fine Adjustment].
Press [-] or [+] to adjust the percentage (%) ➞ press [OK].
If you are making an adjustment to either the X (horizontal) or Y (vertical)
direction, press [-] or [+] to enter a value for that direction only.