Motorola Netopia 2200 Series User Manual page 289

CONFIG Commands
set vlan name name ports port tag [ off | on ]
If set to on, packets transmitted from this port through this VLAN must be tagged with the
VLAN VID. Packets received through this port destined for this VLAN must be tagged with
the VLAN VID by the source. The tag option is only available on global type ports.
set vlan name name ports port priority [ off | on ]
Enables or disables the priority for the port assigned to the specified VLAN allowing
packet prioritization based on any 802.1p priority bits in the VLAN header to prioritize pack-
ets within the Gateway's internal queues, according to DiffServ priority mapping rules.
set vlan name name ports port promote [ off | on ]
Enables or disables the promote setting allowing writing any 802.1p priority bits into the
IP-TOS header bit field for received IP packets on this port destined for this VLAN. Write any
IP-TOS priority bits into the 802.1p priority bit field for tagged IP packets transmitted from
this port for this VLAN. All mappings between Ethernet 802.1p and IP-TOS are made via
diffserv dscp-map settings.
set vlan name name ports port port-pbits [ 0 - 7 ]
Specifies the 802.1p priority bit for this port associated with the specified VLAN. If you set
this to a value greater than 0, all packets of this port with unmarked priority bits (pbits) will
be re-marked to this priority.
set vlan name name ip-interface ip_interface
Associates this VLAN with the specified IP interface. By default the ip-vcc1 and ip-eth-a
interfaces are available, but others may be defined.
set vlan name name inter-vlan-routing [ group-1... group-8 ] [ off | on ]
When set to on, inter-vlan-routing allows VLANs in the specified group to route traffic to
the others; ungrouped VLANs cannot route traffic to each other.
You must save the changes, exit out of configuration mode, and restart the Gateway for the
changes to take effect.
289