set wireless mode { both-b-and-g | b-only | g-only }
Specifies the wireless operating mode for connecting wireless clients: both-b-and-g, b-
only, or g-only, and locks the Gateway in that mode.
☛
set wireless multi-ssid option { on | off }
Enables or disables the multi-ssid feature which allows you to add additional network
identifiers (SSIDs or Network Names) for your wireless network. When enabled, you can
specify up to three additional SSIDs with separate privacy settings for each. See below.
set wireless multi-ssid {second-ssid | third-ssid | fourth-ssid } name
Specifies a descriptive name for each SSID. when multi-ssid option is set to on.
set wireless multi-ssid second-ssid-privacy { off | WEP | WPA-PSK |
WPA-802.1x }
set wireless multi-ssid third-ssid-privacy { off | WEP | WPA-PSK |
WPA-802.1x }
set wireless multi-ssid fourth-ssid-privacy { off | WEP | WPA-PSK |
WPA-802.1x }
Specifies the type of privacy enabled on multiple SSIDs when multi-ssid option is set to
on. off = no privacy; WEP = WEP encryption; WPA-PSK = Wireless Protected Access/Pre-
Shared Key; WPA-802.1x = Wireless Protected Access/802.1x authentication. See
less Privacy Settings" on page 284
☛
278
NOTE:
If you choose to limit the operating mode to B or G only, clients using the
mode you excluded will not be able to connect.
NOTE:
WEP is supported on only one SSID at a time, and will not be available if
another SSID already has it configured.
for more information.
"Wire-