CONFIG Commands
show snmp v3 engine-id
Displays the router's SNMP Engine ID. This is not editable.
System Settings
You can configure system settings to assign a name to your Motorola Netopia® Gateway
and to specify what types of messages you want the diagnostic log to record.
set system name name
Specifies the name of your Motorola Netopia® Gateway. Each Motorola Netopia® Gateway
is assigned a name as part of its factory initialization. The default name for a Motorola
Netopia® Gateway consists of the word "Netopia-3000/XXX" where "XXX" is the serial
number of the device; for example, Netopia-3000/9437188. A system name can be 1 –
255 characters long. Once you have assigned a name to your Motorola Netopia® Gateway,
you can enter that name in the Address text field of your browser to open a connection to
your Motorola Netopia® Gateway.
☛
NOTE:
Some broadband cable-oriented Service Providers use the System Name as
an important identification and support parameter. If your Gateway is part of
this type of network, do NOT alter the System Name unless specifically
instructed by your Service Provider.
set system diagnostic-level
{ off | low | medium | high | alerts | failures }
Specifies the types of log messages you want the Motorola Netopia® Gateway to record.
All messages with a level equal to or greater than the level you specify are recorded. For
example, if you specify set system diagnostic-level medium, the diagnostic log will retain
medium-level informational messages, alerts, and failure messages. Specifying off turns
off logging.
Use the following guidelines:
• low
- Low-level informational messages or greater; includes trivial status messages.
269