Motorola Netopia 2200 Series User Manual page 190

then enter the configuration values appropriate for your site without having to enter com-
plete CLI commands.
When you are in step mode, the command line interface prompts you to enter required and
optional settings. If a setting has a default value or a current setting, the command line
interface displays the default value for the command in parentheses. If a command has a
limited number of acceptable values, those values are presented in brackets, with each
value separated by a vertical line. For example, the following CLI step command indicates
that the default value is
You can accept the default value for a field by pressing the Return key. To use a different
value, enter it and press Return.
You can enter the CONFIG step mode by entering
archy. You can enter step mode for a particular service by entering
In stepping set mode (press Control-X <Return/Enter> to exit. For example:
Validating Your Configuration
You can use the
tings have been entered correctly. If you use the
Netopia® Gateway verifies that all required settings for all services are present and that
settings are consistent.
You can use the
Your Motorola Netopia® Gateway automatically validates your configuration any time you
save a modified configuration.
190
off and that valid entries are limited to
option (off) [on | off]:
Netopia-3000/9437188 (top)>> set system
...
system
name ("Netopia-3000/9437188"): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
validate
CONFIG command to make sure that your configuration set-
Netopia-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
validate
command to verify your configuration settings at any time.
on and
on
set
from the top node of the CONFIG hier-
set
validate command, the Motorola
off .
.
service_name