CONFIG Commands
DMT Settings
DSL Commands
set dmt dsl-annex-support [ off | on ]
This controls whether other annex support (just as Annex M) is enabled. Default is off.
set dmt type [ lite | dmt | ansi | multi | adsl2 | adsl2+ | readsl2 |
adsl2anxm | adsl2+anxm ]
Selects the type of Discrete Multitone (DMT) asynchronous digital subscriber line (ADSL)
protocol to use for the WAN interface.
The type value also supports the following settings on certain model units: adsl2, adsl2+,
readsl2, adsl2anxm, adsl2+anxm.
☛
NOTE:
Some dmt type settings are now supported for many Annex B (335xN) plat-
forms. 2200 Series and 33xxN Series models are supported. Currently,
adsl2anxm and adsl2+anxm are not supported in Annex B.
set dmt autoConfig [ off | on ]
Enables support for automatic VPI/VCI detection and configuration. When set to on (the
default), a pre-defined list of VPI/VCI pairs are searched to find a valid configuration for
your ADSL line. Entering a value for the VPI or VCI setting will disable this feature.
set dmt dmt dying-gasp [ default | off | on ]
Enables or disables Gateway "dying gasp" behavior in cases of power failure. Default is
off.
set dmt wiringMode [ auto | tip_ring | A_A1 ]
(not supported on all models) This command configures the wiring mode setting for your
ADSL line. Selecting auto (the default) causes the Gateway to detect which pair of wires
207