Motorola Netopia 2200 Series User Manual page 242

set pinhole name name internal-port [ 0 - 65535 ]
Specifies the port number your Motorola Netopia® Gateway should use when forwarding
traffic of the specified type. Under most circumstances, you would use the same number
for the external and internal port.
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, port authentication set-
tings, and peer authentication settings for PPP interfaces on your Motorola Netopia® Gate-
way.
Configuring Basic PPP Settings.
☛
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Motorola Netopia® Gateway.
set ppp module [vccn] auto-connect { on | off }
Supports manual mode required for some vendors. The default on is not normally
changed. If auto-connect is disabled (off), you must manually start/stop a ppp connection.
set ppp module [vccn] mru integer
Specifies the Maximum Receive Unit (MRU) for the PPP interface. The integer argument
can be any number between 128 and 1492 for PPPoE; 1500 otherwise.
set ppp module [vccn] magic-number { on | off }
Enables or disables LCP magic number negotiation.
242
NOTE:
For the DSL platform you must identify the virtual PPP interface [vccn], a num-
ber from 1 to 8.