Motorola Netopia 2200 Series User Manual page 196

set atm [vccn] pppoe-sessions { 1 ... 8 }
Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The
total number of pppoe-sessions and PPPoE VCCs configured must be less than or equal
to eight.
Bridging Settings
Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to
forward non-TCP/IP traffic from one network to another. When bridging is enabled, the
Motorola Netopia® Gateway maintains a table of up to 512 MAC addresses. Entries that
are not used within 30 seconds are dropped. If the bridging table fills up, the oldest table
entries are dropped to make room for new entries.
Virtual circuits that use IP framing cannot be bridged.
☛
Common Commands
set bridge sys-bridge {on | off }
Enables or disables bridging services in the Motorola Netopia® Gateway. You must enable
bridging services within the Motorola Netopia® Gateway before you can enable bridging for
a specific interface.
set bridge concurrent-bridging-routing {on | off }
Enables or disables Concurrent Bridging/Routing.
set bridge dhcp-filterset " string "
Assigns a filterset named string to the bridge configuration.
196
NOTE:
For bridging in the 3341 (or any model with a USB port), you cannot set the
bridge option off, or bridge ethernet option off; these are on by default
because of the USB port.