Assign Zone Voice Descriptors - Honeywell Lynx Plus Series Installation And Setup Manual

Lynx Plus Series Installation and Setup Guide
✻84 Assign Zone Voice Descriptors
Use this mode to assign voice descriptors for each zone. These are the descriptors that are announced
when the system announces any event involving a zone number. Each descriptor can consist of up to
3 words. To access this mode, Enter
prompts in detail. The left column identifies the prompts and lists the available entries. The right
column provides a further explanation of the entries.
Note: Entering a number other than the one specified will give unpredictable results.
84 84 84 84
ZONE ZONE VOICE ZONE ZONE VOICE VOICE VOICE DESC DESC DESC DESC
A A A A
ZONE NUMBER ZONE ZONE ZONE NUMBER NUMBER NUMBER
b
DESCRIPTOR 1 DESCRIPTOR 1
DESCRIPTOR 1 DESCRIPTOR 1
.
C C C C
DESCRIPTOR 2 DESCRIPTOR 2
DESCRIPTOR 2 DESCRIPTOR 2
d
DESCRIPTOR 3 DESCRIPTOR 3
DESCRIPTOR 3 DESCRIPTOR 3
✻
84 while in Programming mode. The following explains these

Assign Zone Voice Descriptors

Entering "1" advances to the next prompt below. Entering "0" exits mode, upon which
prompt "84" blinks, indicating the mode is inactive.
SELECTIONS
0 = exit mode
1 = enter mode
Zone Number
Enter the 2-digit zone number for which this descriptor is being assigned, then press [✻].
The Voice Descriptor for the selected zone will be announced, if it is programmed.
SELECTIONS
[✻] = continue to next prompt (any existing descriptors will be announced, then descriptor
1 will be repeated)
00 = exit voice descriptor mode
Descriptor 1
Enter the first word of the descriptor for the selected zone. Use the [6] or [8] key to
advance as described. To change the entered index number before pressing [6] or [8],
simply press [#] + desired 2-digit vocabulary index number. If descriptor 1 is not
desired, enter [#] + 99 (blank), then press [8] to return to zone number prompt.
SELECTIONS
Enter [#] + 2-digit vocabulary index number of first descriptor word for this zone.
6 = accept word and advance to descriptor 2 (descriptor 2 will be announced)
8 = accept word and advance to prompt (A) for next zone. Press any other key to repeat the
selected word.
Descriptor 2
Enter the second word of the descriptor for the selected zone. Use the [6] or [8] key to
advance as described. To change the entered index number before pressing [6] or [8],
simply press [#] + desired 2-digit vocabulary index number. If descriptor 1 is not desired,
enter [#] + 99 (blank), then press [8] to return to zone number prompt.
SELECTIONS
Enter [#] + 2-digit vocabulary index number of second descriptor word for this zone.
6 = accept word and advance to descriptor 3 (descriptor 3 will be announced)
8 = accept word and advance to prompt (A) for next zone. Press any other key to repeat the
selected word.
Descriptor 3
Enter the last word of the descriptor for the selected zone. Use the [6] or [8] key to
advance as described. To change the entered index number before pressing [6] or [8],
simply press [#] + desired 2-digit vocabulary index number. If descriptor 3 is not desired,
enter [#] + 99 (blank), then press [8] to return to zone number prompt.
SELECTIONS
Enter [#] + 2-digit vocabulary index number of third descriptor word for this zone.
6 or 8 = accept word and advance to prompt (A) for next zone. Zone descriptor will be announced.
Press any other key to repeat the selected word.
- 52 -