Ac Power And Rechargeable Backup Battery - Honeywell Lynx Plus Series Installation And Setup Manual

Lynx Plus Series Installation and Setup Guide
AC Power and Backup Battery

AC Power and Rechargeable Backup Battery

The Lynx Plus Series is equipped with an integral, replaceable, rechargeable battery pack rated at 7.7Vdc.
Select the appropriate battery pack, based on the installation's requirement, and install the battery pack.
Battery Part Number
LYNXRCHKIT-SC
LYNXRCHKIT-HC
LYNXRCHKIT-SHA
Replacing the Rechargeable Battery
1. When battery replacement is required, unplug the transformer from the wall outlet, and open the control panel cover.
2. Remove the screw that secures the battery retainer.
3. Remove the battery retainer and disconnect the battery pack connector from the receptacle on the PC board.
4. Remove the battery pack from the back plate.
5. Install a replacement battery pack (P/N LYNXRCHKIT-SC, LYNXRCHKIT-HC or LYNXRCHKIT-SHA) into the back plate.
6. Install the battery retainer.
7. Secure battery retainer with the provided screw as shown below.
8. Connect the battery connector to the appropriate receptacle on the PC board.
9. After the wiring connection has been made, snap the front assembly and the back plate closed.
10. Plug the transformer into a 24-hour, 110VAC unswitched outlet.
11. Rechargeable batteries may take up to 48-hours to fully charge. The "LOW BAT" message should clear within four
hours or by entering Test Mode.
Ensure the control panel assembly is snapped closed prior to applying AC power.
Battery StandbyTime
4-hours (minimum)
24-hours (minimum)
24-hours (minimum)
SCREW
RETAINER
LYNXRCHKIT-SHA/
LYNXRCHKIT-HC
Low Battery Notification
Approximately 1-hour before battery depletion
At least 1-hour before battery depletion
At least 1-hour before battery depletion
RETAINER
OR LYNXRCHKIT-SC
- 12 -
SCREW
1000-300-010-V0