Slide Rails (Cabinet); Remove And Re-Install; Slide Rails (Bucket) - Broan Elite 15XEWH Service Manual

Slide Rails (Cabinet)

REMOVE AND RE-INSTALL

The compactor's slide rails may become bent from mis-
use or the ball bearings may become worn.
1. Remove trash bucket assembly. (See Trash Bucket,
Remove.)
2. Remove two Phillips head screws from the front and
rear of the left track slide rail. NOTE: It is necessary to
slide the inner rail to access both screws.
3. Remove the slide rail from the cabinet.
4. To re-install, place slide rail onto the three "spring
clips" inside of the cabinet. Align holes in rail with
bracketed holes on inside of cabinet and secure with
two Phillips head screws. Repeat for other side.
SPRING CLIPS
SCREW
RAIL
NUT
SCREWS
Section B – Cabinet

Slide Rails (Bucket)

REMOVE AND RE-INSTALL
BUCKET
1. Remove four Phillips head screws that secure the left
slide rail to the bucket. Remove the rail.
2. Repeat Step 1 for the right slide rail.
3. Installation is the reverse of removal.
RAIL
SCREW
SCREWS
9