28
Section D – Electrical Components
Display Module Assembly
REMOVE AND RE-INSTALL
The display module assembly contains switches and LEDs
that allow the operator to turn the compactor ON and
OFF, and to place it in LOCK mode; to select HOLD or
NORMAL mode; to start the compactor cycle; to set the
clock and delay mode; to monitor odor control, and to reset
and advance the odor control disk. If LEDs or switches
are worn, replace the display module.
1.
Remove the control panel assembly from the unit (see
Control Panel Assemby, Remove and Re-install).
ODOR DISK
SWITCH
2.
Disconnect the battery connector and odor disk
switch from the control panel.
3.
Remove fi ve Phillips head screws and the display
module assembly from the control panel.
4.
Installation assembly is the reverse of removal. NOTE:
First install display module assembly to panel, then
re-attach wiring.
BATTERY
CONNECTOR
SCREWS
Power Supply Board
REMOVE AND RE-INSTALL
The power supply board directs electrical power to all
areas of the compactor, including the control board, the
main motor and the odor control motor.
CONTROL
DISPLAY
BOARD
PANEL
CONTROL
PANEL
1.
Remove the control panel and display module
assembly (see Control Panel Assembly, Remove and
Re-install and Display Module Assembly, Remove
and Re-install).
SCREWS
2.
Remove four Phillips head screws from the display
module assembly rear cover.
SCREWS
SCREWS
REAR
COVER
POWER
SUPPLY
BOARD