Top Trim Cover Assembly; Remove And Re-Install - Broan Elite 15XEWH Service Manual

1. Remove door assembly (see Door Assembly, Remove
and Re-install).
2. Remove control panel (see
Control Panel Assembly).
3. Lift the outer edge of the gasket to expose the
retainer strips and the screws that are used to fasten
the strips to the cabinet. NOTE: There are six retainer
strips: two each on the top and bottom and one each
for the left and right sides.
4. Remove the Phillips head screws that secure the
retainer strips to the cabinet; then remove the strips
from underneath the gasket. Pull the gasket off of the
cabinet.
5. To install a new gasket, place retainer(s) under the
outer edge of the gasket, then use the screws to
fasten the retainers and gasket to the cabinet.
6. Re-install the control panel.
Electrical Components,
Section B – Cabinet

Top Trim Cover Assembly

REMOVE AND RE-INSTALL

1. Remove the door (see Door Assembly, Remove and
Re-install).
SCREWS
2. Remove the four Phillips head screws that secure the
top trim cover to the cabinet.
3. Pull the top trim cover away from the cabinet.
4. Re-install in reverse order. Be careful not to over-
tighten screws.
15