Broan Elite 15XEWH Service Manual page 12

12
Section B – Cabinet
TRIM PIECE
4. Use a screwdriver to remove the upper hinge pin from
the trim piece and re-install the pin on the opposite
side.
5. Being careful not to scratch the door, remove the
plastic door bushing and cap from the top and bottom
of the door using a small fl at screwdriver. Install the
bushings on the side of the door panel that will be
hinged and install the caps on the opposite side.
6. Re-install the door (see Remove and Re-install — All
Doors Except Wood and Tile).
CAP
BUSHING
DOOR
REVERSE DOOR HINGE POSITION —
WOOD AND TILE DOORS
The compactor comes from the factory with the door in
the right-hand opening position. To reverse the door, use
UPPER
the following instructions for trash compactors with tile or
HINGE
wood door kits. On these door pans, the hinge pins are
PIN
permanently attached.
1. Remove the door pan from the cabinet (see Remove
and Re-install — Wood and Tile Doors).
2. Remove the actuator (see Safety Interlock Actuator,
Remove and Re-install — Wood and Tile Doors).
3. Rotate the door pan until the hinge pins are on the
desired side.
4. Locate the lower hinge bracket and screws removed
from the cabinet during door removal.