Image Editing; Trimming/Masking - Toshiba e-studio 45 Operator's Manual

5. IMAGE EDITING

Trimming/Masking

You can select areas on an original and copy it with the areas trimmed (only the inside of the areas
copied) or masked (only the outside of the areas copied). Up to four areas can be specified on an
original.
* If the settings of the original and copy sizes are not made appropriately, the image may not be copied
completely.
* When using this mode in bypass copying, be sure to specify the copy size.
* Image editing is only possible with Standard sized originals.
Original
1 Place an original on the glass to specify areas.
• Set the original face up with the bottom toward you, fit its
top left corner against the top left corner of the glass, and
align it with the original scale.
2 Using the original scale on the left and the inner
(top) scale, read the position of the desired area,
as follows:
• X1 Distance from the top left to the left edge of the speci-
fied area.
• X2 Distance from the top left to the right edge of the speci-
fied area.
• Y1 Distance from the top left to the upper edge of the speci-
fied area.
• Y2 Distance from the top left to the lower edge of the speci-
fied area.
3 Press the EDIT key to enter the editing menu. Then,
press the EDITING key.
• If the key for the desired function is not shown, press the
Pre key to switch the screen.
Trimming copy
Page 3-4
Masking copy
1
2
3
4
5
6
7
8
9
10
11
12
4-7