Toshiba e-studio 45 Operator's Manual page 156

Cleaning the Reversing Automatic Document Feeder (optional)
If the scanning area (transport belt) is dirty, it may cause the
original jam or dirty copies. A dirty Mylar may also create dirty
copies.
• Clean the transport belt with a cloth moistened with
small amount of water, alcohol or a neutral deter-
gent, then wipe off the detergent completely with a
dry cloth.
Cleaning the Charger
If the inside of the charger and the wire become dirty, the dirt
may appear on the copy.
* Before start cleaning, BE SURE TO TURN OFF THE MAIN
POWER SWITCH, then open the front cover.
1 Open the front cover.
2 Clean the charger.
• Hold the cleaning knob, pull it out slowly and fully to the
front and then push it back to the inside carefully and com-
pletely. Repeat this 2 or 3 times.
Note
Make sure that the charger knob is pushed in fully inside.
3
Close the front cover.
1
2
3
4
5
6
7
8
9
10
11
12
8-3