Table of Contents
Advertisement
EN
2.3
Attach the dome window to the camera module, aligning
the blue LOCK labels.
Snap the dome cover into position by pressing
gently on the dome 90° from the blue labels.
90°
BLUE
LABEL
Photo 2C Attach dome window
2.4
While holding the top of the camera, rotate the lower
portion and align the camera dome yellow markers.
Photo 2D Align yellow markers
With the red dot on the camera module facing the red
2.5
dot on the backbox, slide the camera module into the
backbox module using the guides. Note that the camera is
shown turned 180 degrees to illustrate red markers.
RED
MARKERS
Photo 2E Align red markers
© 2005 Bosch Security Systems
90°
YELLOW
MARKERS
While grasping the unit by the dome window, insert the
2.6
camera module completely into the backbox.
RED DOTS
FACING
EACH
OTHER
Photo 2F Insert camera module
While pressing up, twist the dome window/locking ring
2.7
clockwise approximately 1/4 turn. The camera will
initialize ten seconds after it is properly installed.
Photo 2G Lock dome into place
An optional tamper clip is provided to prevent the dome
2.8
from being removed. To install, locate the blue label,
orient the tamper clip with the two tabs pointing up, and
press the tamper clip into the locking ring just to the
right of either blue label. A straight blade screwdriver
will help push the clip in place.
Section 2
TURN TO
LOCK
Page 12 of 40
Hide quick links:
Advertisement
Table of Contents
