Assembly - MK Diamond Products CX-3 Owner's Manual & Operating Instructions

CX-3
®
Diamond Blade Installation
When installing the diamond blade retaining-bolt, ensure the threads of the bolt are aligned
NOTE:
with the threads of the drive shaft so as not to "cross-thread" the bolt.
(A)
Locate Blade Guard lock.
(D)
Loosen the Blade Retaining Bolt
while holding the Shaft Wrench
steady. Remove the Blade Retain-
ing Screw and Outer Flange.
(G)
Install the Blade Retaining Bolt.
WARNING
Diamond Blades improperly used are dangerous. Comply with American National Standards Institute
Safety Code, B7.1 and, Occupational Safety and Health Act covering Speed, Safety Guards, Flanges,
Mounting Procedures, General Operating Rules, Handling, Storage and General Machine Conditions.
(B)
Push Lock Button. Open the
Blade Guard cover.
(E)
Install the Diamond Blade onto
the Blade Shaft. Ensure arrow is
pointed in direction of rotation.
(H)
Tighten Blade Retaining
Bolt while holding the Blade
Shaft steady.
14

ASSEMBLY

(C)
Locate the Blade Retaining Bolt
and the Outer Flange.
(F)
Install the Outer Flange. Verify
it is seated against the blade.