Download
Share
Print this page
  1. Manuals
  2. Brands
  3. MK Diamond Products Manuals
  4. Saw
  5. MK-101
  6. Operating instructions manual

MK Diamond Products MK-101 Operating Instructions Manual

Tile saw
Hide thumbs Also See for MK-101:
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual See also: Owner's Manual, Operating Instructions and Owner's Manual
MK-101
TILE SAW
OWNER'S MANUAL &
OPERATING INSTRUCTIONS
CAUTION:
Read all safety and
operating instructions
before using this
equipment
Enter the Serial Number of your new saw in the
space below. The Serial Number is located on the
left side of the blade guard.
SERIAL NUMBER:
NOTE:
For your (1) one year warranty to be effective,
complete the warranty card (including the Serial
Number and mail it in as soon as possible.

Advertisement

loading

Related Manuals for MK Diamond Products MK-101

Summary of Contents for MK Diamond Products MK-101

  • Page 1 MK-101 TILE SAW OWNER’S MANUAL & OPERATING INSTRUCTIONS CAUTION: Read all safety and operating instructions before using this equipment Enter the Serial Number of your new saw in the space below. The Serial Number is located on the left side of the blade guard.

  • Page 2: Setup, Adjustment And Operation

    2. Connecting the Water Pump: To prevent the possibility electrical shock, the MK-101 MUST be de-energized when connecting the Water Pump. To prevent the possibility of electrical shock, use only MK Diamond qualified replacement parts NOTE: To prevent pump damage, the Water Pump must be disconnected if cutting with a Dry Blade.

  • Page 3: Water Pump Setup For Operation

    Fill the Water Basin until water Ensure the Drain Plug is Place the Water Pump in the completely covers the Installed in the Water Basin back of the Water Basin Water Pump suction Page 16 MK-101 Revision 4/01, Effective Date April 29, 2001...

  • Page 4: Set Cutting Depth

    Check for damaged, broken, or missing parts. 2. Verify the On/Off switch is in the OFF position. 3. Before connecting the MK-101 to a power supply, be sure the voltage, cycle and phase of the job site power source meet the requirements of TABLE 3...

  • Page 5: Adjustment And Operation

    Ruler/Stop and Cutting Guide Maintenance Section to increase/decrease flow) ON/OFF Hold Work Switch in Position Position Direction of Cut Perform the cut Turn the motor OFF when work is complete Page 18 MK-101 Revision 4/01, Effective Date April 29, 2001...
  • Page 6 45º Flat Angle Guide and the Maintenance Section to Ruler/Stop increase/decrease flow) ON/OFF Hold Work Switch in Position Position Direction of Cut Perform the cut Turn the motor OFF when work is complete Page 19 MK-101 Revision 4/01, Effective Date April 29, 2001...