MK Diamond Products CX-3 Owner's Manual & Operating Instructions page 29

CX-3
®
(M)
Install the Pointer on the oppo-
site side, next to Blade Guard.
Belt Adjustment and Replacement
In order to ensure the CX-3
ed monthly and changed if any signs of damage and/or excessive wear is observed.
NOTE: 1. When a new belt is installed, it should be inspected and retensioned after the first
forty-eight (48) hours of operation.
(A)
Remove the Blade
(See Blade Removal section).
(D)
Check belt for proper tension if ten-
sion is correct, go to Step P (Proper
tension is approximately 1/8-inch
deflection of the belt).
operates at peak efficiency, the power transmission belt should be inspect-
®
Locate and remove the Belt
Guard Retaining Bolts and then
remove the Belt Guard.
Locate the four upper Engine
Mounting Nuts on both ends of
the CX-3 motor and loosen.
®
(B)
(E)
29
MAINTENANCE
(C)
Inspect the belt for excessive
wear, cracks and cuts – if worn,
proceed to Step E.
(F)
Locate the four lower Engine
Mounting Bolts on both ends of
the CX-3 motor and loosen.
®