Operation - MK Diamond Products CX-3 Owner's Manual & Operating Instructions

CX-3
®
Standard Operation
The following is a brief overview of operating the CX-3
(A)
Use the depth control wheel to
raise the blade clear of the floor.
(D)
Tighten thumbscrew.
(G)
With the engine running adjust
the throttle approximately half-
way.
®
(B)
Attach the cooling supply
hose to the Cooling Inlet.
(E)
Layout and mark the area to
be cut using a chalk-line. Align
Pointer and Blade to chalk-line.
(H)
Open Cooling Supply Valve. Ver-
ify proper cooling flow and adjust
the water flow on the Blade to a
desired amount.
18
.
Lower the Pointer. Align a straight-
edge with a blade. Loosen thumb-
screw on front of Pointer to adjust
guide wheel, align with straightedge.
Start the CX-3
Start procedure in the Engine
Adjust the throttle as needed to
make the cut. Slowly lower the
Blade until the desired level is
reached and begin the cut.

OPERATION

(C)
(F)
using the Engine
®
Manual.
(I)