Transfer Roller; Register Roller - Brother HL-2400C Service Manual

4.6.2

Transfer Roller

1) Lift the transfer roller lock lever to release the right hand end of the roller. The angle
of lifting the lock lever is approx. 80° from the horizontal.
2) Push the tab of the left hand side to remove the shaft from the installation hole at the
right side first, then remove the transfer roller.
3) Remove the transfer roller.
Tab
4.6.3

Register Roller

1) Remove the roller fixing C rings from both ends of the roller.
2) Remove the gear from the shaft (left hand side).
3) Remove the plastic bushes at both ends.
4) Remove the shaft support from the frame while pressing down on the pressure roller
to release the pressure from the register roller.
5) Remove the register roller.
Gear
C ring
Fig.7-69
Plastic bush
Fig.7-70
VII-41
Transfer Roller
Lock lever
Register Roller
Plastic bush
C ring