Brother HL-2400C Service Manual page 46

Note: Refer to the table below for each test mode item.
Display Message
DEMO PAGE
TEST PRINT
PRINT CONFIG
PRINT FONTS I
PRINT FONTS C
PRINT FONTS P
exit
10) Push the power button in order to shut off the power supply to the printer.
Note: use the following procedures to identify the problem if the test print is incorrect.
11) Press and hold down the Mode, Set and
buttons and press the power button
to go into the Engine Controller Mode.
The Ready LED lights within 210
seconds maximum, when the screen (a)
on the right appears on the control
panel display.
12) Press the Select key, then the screen
(b) on the right appears on the control
panel display.
13) The printer has two built-in print
patterns for test printing in the Engine
Controller Mode as follows. Use the Set
or button to scroll through the menu
options and then press the Continue
key to perform the selected test print.
Press Font to stop the test print.
1. Grid Pattern:
Available in mono color print of Y,
M, C, K, and two color print of R, G,
B.
2. Stripe Pattern:
Available in color print of Y, M, C, K,
R, G, B.
Test Mode Description
Prints out the demonstration.
Performs the printer test and prints
out the test pattern.
Prints out a list of panel button
settings you have configured as
user settings for the printer.
Prints out a list of internal or
resident fonts.
Prints out a list of optional fonts
stored in the font cartridge/card.
Prints out a list of permanent
download fonts.
Exits from the test mode. The
printer does not perform any test.
(a)
00
U:[
(b)
SERVICE MODE
TEST PRINT/NEXT
III-9
READY [ ]
] L:[ ] [ ]
Grid
Stripe