Base Cover (L); Upper Cover - Brother HL-2400C Service Manual

4.2.4

Base Cover (L)

1) Remove the set screws TS4X8 (2 pcs.) from the base cover (L).
2) Remove the base cover (L) from the base.
Note:
If the optional lower tray unit is fitted, it will be necessary to remove the lower tray clamp
screw and locking bar to release the base cover (R). For further information, refer to the
User Guide.
•
When re-assembling the base cover, insert the leading edge of the base cover (L) into
the hook provided at the bottom (left and right) of the base plate.
•
Ensure that the projecting part (
base plate bottom.
4.2.5

Upper Cover

1) Open the front cover and release the belt cartridge lock levers.
2) Remove the side cover (R).
3) Remove the set screws BT4X8 (2 pcs.) securing the upper cover. (Top X 1 and Right
hand side X 1)
4) Slightly lift up the rear edge of the upper cover.
5) Pull the upper cover toward you and unhook the hook at the front of the cover from
the frame.
Upper Cover
PRECAUTION
) of the base cover (L) goes into the hole in the
Hook
VII-19
Base Cover (L)
Fig.7-28
Fig.7-29