Brother HL-2400C Service Manual page 313

iii) Check that the value of NEXT CARE is reset correctly.
(i.e.) NC8 = 39,684P
iv) Reset the LIFE PERIOD counter in FACTORY MODE to 60,100.
7) Re-enter the 120K KIT (NC9) value as follows;
i) Enter the value of NC9 - LP9 into the TOTAL PAGE counter.
(i.e.)
Enter the value '0' into the TOTAL PAGE counter.
ii) Perform CLEAR CARE 9. (Refer to '36 CLEAR CARE' in page V-24 of Chapter
V.)
iii) Check that the value of NEXT CARE is reset correctly.
(i.e.) NC9 = 120,000P
8) Re-enter the original TOTAL PAGE (T) value in TOTAL PAGE SET in FACTORY
MODE.
(i.e.) T = 412P
9) Re-enter the original EACH IMAGE (IY, IM, IC, IK) values in EACH IMAGE SET in
FACTORY MODE.
(i.e.) (IY)=348P, (IM)=353P, (IC)=365P, (IK)=439P
10) Ensure that the values in the LIFE PERIOD SET counters in FACTORY MODE
are correct.
(i.e.) FC ROLL (LP2)=12,000P
BL UNIT (LP7)=50,000P
FU UNIT (LP8)=60,100P
120K KIT (LP9)=120,000P
11) Completed.
NC9 - LP9 = 120,000 - 120,000 = 0
A-10