Brother HL-2400C Service Manual page 137

Code No.
14-1 CHECK FUSER OIL
14 CHECK
14-2
14 CHECK CLEANING
14-3 CHECK WASTE TONER PACK
14 CHECK
15 MISPRINT
15 MISPRINT
16-1
16 ALIGN
LCD Message
[*5]
FUSER OIL[*F0]
ROLLER[*4][*FC]
TONER PACK[*4]
[*6][*4]
FU.UNIT [*4]
V-16
Description of Message
• The engine is idling.
• The Ready LED is lit.
• Replace the fuser oil bottle with a new
one.
• This message will be automatically
cleared by opening & closing the
paper exit cover.
• The engine is idling.
• The Ready LED is lit.
• Replace the cleaning roller with a new
one.
• Execute the Clear Care Mode after
the replacement of the cleaning roller
to clear the Care Code [FC].
• The engine is idling.
• The Ready LED is lit.
• Replace the waste toner pack with a
new one.
• This message will be automatically
cleared by opening & closing the front
cover while replacing the waste toner
pack. The message can also be
cleared by pressing the Font button.
• The engine is idling.
• The Ready LED is lit.
[*6] The type of misprint error is
indicated as follows;
NOPQR: No PRREQ-N signal is
available.
PAPER: No paper is available in
the feeder while executing the print
operation after receipt of the print
command.
• This message can be cleared by
pressing the Font button.
• The engine is stopped.
• The Ready LED is lit.
• The fusing unit is not installed.
Reconfirm the installation status of the
fusing unit.
• This message will be automatically
cleared by opening & closing the
paper exit cover. The message can
also be cleared by pressing the Font
button.