Panel Pcb (Including Lcd); Side Cover (L) - Brother HL-2400C Service Manual

4.2.2

Panel PCB (including LCD)

1) Remove the set screw BT4X10 (1 pc.) from the panel case assembly and disconnect
the connector. (Refer to Figure 7-26 below.)
2) Remove the set screws BT3X8 (4 pcs.) from the panel PCB and remove the panel
shield plate, PCB and LCD from the panel case assembly.
Panel Case
Assembly
4.2.3

Side Cover (L)

1) Remove the set screw BT4X8 (2 pcs.) of side cover (L).
2) Remove the side cover (L).
(Slowly pull up the side cover (L), and release the hook from the front of the Upper
cover.)
Panel PCB
Panel shield plate
Connector
Control Panel
Fig.7-26
Fig.7-27
VII-18
Panel case
Panel top cover
LCD PCB
Disconnect the connector
Hook
Cover (L)