Canon iPF9000S Troubleshooting Manual page 49

Panel display
Code
(last 4
Large LCD
digits)
2E16 Wrong paper type.
Check paper type
setting on computer.
Online: Print
Stop: Stop Printing
Wrong paper type
and size. Check
paper type and size
setting on computer.
Online: Print
Stop: Stop Printing
Wrong paper type
and size. Check
paper type and size
setting in driver.
Online: Print
Stop: Stop Printing
2E17 No cassette
detected.
Check the cassette.
2E18 Cannot load.
Press Load/Eject
and reload the
paper.
2E19 Cannot load.
Press Load/Eject
and reload the
paper.
2E1A Cannot load.
Press Load/Eject
and reload the
paper.
2E1B The roll is empty.
Load/Eject:
Change Paper
The roll is empty.
Lift the release
lever and replace
the roll.
The roll is empty.
The roll is empty.
Lift the release
lever and replace
the roll.
Out of roll paper.
Push the release
lever back, then
replace the roll.
Small Small
LCD 1 LCD 2
Paper Check Paper mismatch (type)
Mismatch Paper The data type defined in the data and the
Prnt:Pres Press type of actually loaded paper do not match.
sOnline Online Following the transmission of data in the
GARO format, all of the following conditions
have been met at the start of printing:
・The paper type that has been set in the job
・[Stop] has been selected for [Paper
Cassette Check Cassette not installed
Undetecte Cassette
d Press
Online
Remove Cannot Paper not fed as far as the platen
paper Feed
Press
↑ Key
Remove Cannot Feeding error
paper Feed LF out of synchronization for cut sheet
Press
↑ Key
Remove Cannot Feeding error
paper Feed LF out of synchronization for cut sheet
Press
↑ Key
Roll Paper No roll paper available (trailing edge of roll
Paper Not paper detected)
Please Loaded ・Trailing edge of paper has been detected
Replace Press
↑ Key ・LF out of synchronization on roll paper.
Explanation/Detection sequence
and the type of actually fed paper do not
match.
Mismatch Detection].
by paper sensor in a roll paper operation.
(Detected the spool no longer rotating.)
2-37
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Check the paper
that is actually
loaded on the
printer and the
driver paper type
setting.
①Check to see if
the cassette
itself is
properly
loaded.
②Check and
replace sensor
(IO mode).
Go to ★2E27
(P3-14).
①Refeed the
paper.
②★Go to
2E27(P3-14).
①Refeed the
paper.
②★Go to
2E27(P3-14).
①Replace the roll
paper.
②Check paper
sensor R (IO
mode).
③Is the paper fed
successfully
(under a
negative load
or any other
influence)?