Canon iPF9000S Troubleshooting Manual page 52

Code
(last 4
Large LCD
digits)
2E27 Cannot load.
Press Load/Eject
and reload the
paper.
Cannot feed paper
Lift the release
lever and reload
paper.
Cannot feed paper.
Reload the paper.
Paper jam.
Press Load/Eject
and reload the
paper.
Paper jam. Lift
the release lever.
Paper jam.
Push the release
lever back.
Paper jam.
Manually rewind roll
all the way.
Paper jam.
Manually rewind roll
all the way
and press OK.
2E30 The paper is
too small.
2E31 Insufficient paper
for job
2E32 Insufficient paper
for job
Troubleshooting Guide
Panel display
Small Small
LCD 1 LCD 2
Remove Cannot
paper Feed
Press
↑ Key
Paper
Jam
Press
↑ Key
Explanation/Detection sequence
Feeding error (nip release required)
LF out of synchronization (LF motor
won't rotate) has been detected.
Jam while picking up, ejecting or
printing on paper
(A sequence of removing jams with
the pinch roller released is
required)(JAM1)
Virtually all recovery errors that could
occur in connection with paper pickup
are handled.
Paper mismatch (size)
With [Pause] selected for [Paper
Mismatch Detection] in the menu
setting, paper size for the paper
loaded was smaller than the size
specified by data.
All of the following conditions have
been met at the start of external
printing:
・[ON] has been selected for
[Remaining Roll Paper Detection].
・Among the paper size settings
coded in the print data, the paper
length exceeds the remaining
length of roll paper.
・Automatic roll feed to another roll
paper slot which is not the current
feeding path, out of the 2 slots the
printer has, is not available.
All of the following conditions have
been met at the start of external
printing:
・[ON] has been selected for
[Remaining Roll Paper Detection].
・Among the paper size settings
coded in the print data, the paper
length exceeds the remaining
length of roll paper.
・Automatic roll feed to another roll
paper slot which is not the current
feeding path, out of the 2 slots the
printer has, is not available.
2-40
Remedial Action
(★: Reference fault
isolation procedure or
tool)
★Go to
2E27(P3-14).
①Open and close
the release lever
to reload the
paper.
②Remove the
paper once and
then refeed it.
★Go to
2E27(P3-14).
Continued printing
allowed.
Check driver setting
Replace with
appropriate paper.
Replace the roll
paper.
Replace the roll
paper.