Canon iPF9000S Troubleshooting Manual page 14

Panel display
Code
(last 4
Large LCD
digits)
- Sheet printing
is selected.
- Paper Pos Wrong
- Turn on the media
take-up unit.
- Media take-up unit
ready.
Online: Print
Stop: Stop Printing
- End of paper feed.
Cannot feed
paper more.
- Close Ink Tank
Cover
- The roll feed unit
is loose. Push it
all the way in.
- Prepare for parts
replacement.
Call for service.
- Parts replacement
time has passed.
Call for service.
Troubleshooting Guide
Small Small
LCD 1 LCD 2
Paper
Pos
Wrong
Feed
Limit..
Consuma
bles Low
Repl
Consuma
bles
Explanation/Detection sequence
Paper mismatch (cut sheet)
No cassette paper has been loaded when
data having a cut sheet specification is
received.
(Paper type /size not determined)
Invalid paper loading position
Paper is invalidly positioned on the platen.
Printing has started with the media take-up
unit setting of [Use] and with the rewinder
switched off.
Rewinder use has been set to [Do not use]
at the start of printing when the rewinder is
active.
Forced feed limit
Paper being manually fed in the return
direction (back-feeding) has reached the
pinch roller position.
Ink tank cover open while printing
On a model having a subtank, the ink tank
cover opened while printing. (Printing is
allowed to continue.)
The roll unit has been pulled out during
standby or printing on the lower roll paper or
cut sheet A3 or less.
Durable parts replacement due soon
Any of the parts counters has reached
warning level 1.
Durable parts replacement due soon
Any of the parts counters has reached
warning level 2.
2-2
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Load cut sheet.
Go to ★2010
(P3-12).
Switch on the
rewinder.
*A measure for a
third-party
rewinder that is
not connected
to the main unit.
①Press the
[Online] button
to set the
rewinder use
setting to force
[Use] and print.
②Press the
[Stop] key to
cancel printing.
The message
clears
automatically 2
seconds later.
Check the PE
sensor (IO
mode).
The message
clears when the
ink tank cover is
closed.
Check the sensor
(IO mode).
Close the roll unit.
Check the parts
counter and
prepare the target
unit or Refresh
Service Kit.
Initialize the parts
counter for the
target unit after the
replacement.