Canon iPF9000S Troubleshooting Manual page 28

Panel display
Code
(last 4
Large LCD
digits)
2405 Borderless printng
not possible.
Lift the release
lever and reload
the paper.
Online: Print
Bordless Printing
not possible. Lift
release lever and
reload the paper.
Bordless Printing
not possible. Lift
release lever and
reload the paper
Online: Not bordrlss
Stop: Stop Printing
Paper position not
suitable for
borderless printing
Borderless printng
not possible. Check
roll position.
Online: Print
Load/Eject: Change
Paper
Borderless printng
not possible. Check
roll width and
spacers.
Online: Print
Load/Eject: Change
Paper
2406 Borderless printng
not possible. Check
paper size setting.
Online: Print
Load/Eject: Change
Paper
Borderless printng
not possible. Check
supported paper.
Troubleshooting Guide
Small Small
LCD 1 LCD 2
Roll Borderle
Paper ss Prtng
Chk Not
Check Possible
Width/Spc
r
Check No
Supporte Borderle
d ss w/
Paper. This Roll
Paper
Explanation/Detection sequence
Invalid paper loading position (borderless
printing)
The position at which paper is loaded is unfit
for borderless printing.
Data with a borderless print specification has
been received while the left or right edge of
roll paper was off the center of the borderless
print idle ejection port at the completion of roll
paper pickup.
Borderless print data not printable (logic)
Borderless print data was received at the
start of printing and one or more of the
following requirements are met at the same
time:
・A feeder slot other than one for roll paper
has been specified in the data.
・A paper type that does not support
borderless printing has been set on the
data.
・Banner printing has been specified on the
data at the same time.
・A paper size that does not support
borderless printing has been specified in a
job for which paper had already been fed.
2-16
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Reload the roll
paper.
Check spacers
Go to ★2010
(P3-12).
Reset the driver
and RIP.