Table of Contents
Advertisement
Chapter 3
Video Interfaces (J3, J4, J5, J31)
The VT8606 chip provides the graphics control and video signals to the traditional glass CRT monitors
and the LCD and LVDS flat panel displays. The chip features are listed below:
CRT features:
• Supports a max resolution of 1600 x 1200 with video frame buffer set at 8MB
• Supports a maximum allowable video frame buffer size of 32MB shared memory
• AGP 4X graphics (always enabled)
• Compliant with Rev 2.0 of AGP Interface
Flat Panel features:
• Supports (3.3V, 5V, or 12V) output to both DSTN and TFT flat panels through a 36-bit interface
• Supports TFT panel sizes from VGA (320x480) up to SXGA+ and UXGA+ (1400x1050).
• Supports LCD VGA and SVGA panels with 9-, 12-, 18-bit interface (1 Pixel/Clock)
• Supports UXGA and SXGA active matrix panels with 1x24-bit interface (2 Pixels/Clock)
• Supports 1 or 2 channel LVDS outputs
CRT Interface
Table 3-23. CRT Interface Pin/Signal Descriptions (J5)
Pin #
Signal
1
RED
2
GND
3
GREEN
4
GND
5
BLUE
6
GND
7
HSYNC
8
GND
9
VSYNC
10
+5V
Notes: The shaded area denotes power or ground.
52
Description
Red – This is the Red analog output signal to the CRT.
Digital Ground
Green – This is the Green analog output signal to the CRT.
Digital Ground
Blue – This is the Blue analog output signal to the CRT.
Digital Ground
Horizontal Sync – This signal is used for the digital horizontal sync
output to the CRT.
Digital Ground
Vertical Sync – This signal is used for the digital vertical sync output to
the CRT.
+5 volts +/- 5% Fused (F5 is next to J5 connector on board)
Reference Manual
Hardware
LittleBoard 700
Advertisement
Table of Contents
