Ampro Little Board 700 Reference Manual page 77

Chapter 4
♦
Assign IRQ 1 – [Disabled] or [Enabled]
• If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 3 – [Disabled] or [Enabled] (Typically COM2)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 4 – [Disabled] or [Enabled] (Typically COM1)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 5 – [Disabled] or [Enabled]
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 6 – [Disabled] or [Enabled] (Typically Floppy Disk)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 7 – [Disabled] or [Enabled] (Typically LPT1)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
• If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦ Assign IRQ 9 – [Disabled] or [Enabled] (Typically unused)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
♦
Assign IRQ 10 – [Disabled] or [Enabled] (Typically unused)
•
If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play
adapter.
•
If another device in the system is using this IRQ, then this field should be set to
[Disabled].
LittleBoard 700 Reference Manual
BIOS Setup
71