Table of Contents
Advertisement
Chapter 4
NOTE
Ampro does not recommend connecting a USB boot device to the
LittleBoard 700 through an external hub. Instead, connect the USB
boot device directly to the LittleBoard 700.
Any USB (block) device that emulates a hard disk drive can be used
when [USB HDD] is set as the drive option. This includes various
storage media types, such as USB hard disk drives, USB CD-ROMs,
CompactFlash cards, Secure Digital Memory Card, and Flash or
Thumb drives. Refer also to Boot Order settings, USB Boot Support
under Advanced features, and USB (device enable) under On-Board
Controllers for USB Drive boot order, USB Boot Enable, and the
number of USB ports enabled, respectively.
♦
Drive E – [none], [HDD/CF on Pri Master], [CDROM on Pri Master], [HDD/CF on Pri Slave],
[CDROM on Pri Slave], [HDD on Sec Master], [CDROM on Sec Master], [HDD on Sec Slave],
[CDROM on Sec Slave], [USB HDD], or [USB CDROM]
♦
Drive F – [none], [HDD/CF on Pri Master], [CDROM on Pri Master], [HDD/CF on Pri Slave],
[CDROM on Pri Slave], [HDD on Sec Master], [CDROM on Sec Master], [HDD on Sec Slave],
[CDROM on Sec Slave], [USB HDD], or [USB CDROM]
♦
Drive G – [none], [HDD/CF on Pri Master], [CDROM on Pri Master], [HDD/CF on Pri Slave],
[CDROM on Pri Slave], [HDD on Sec Master], [CDROM on Sec Master], [HDD on Sec Slave],
[CDROM on Sec Slave], [USB HDD], or [USB CDROM]
• Boot Order
st
♦
Boot 1
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
nd
♦
Boot 2
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
NOTE
The [Alarm] option sounds beeps on the PC speaker and can be
listed, like [Reboot], as the last boot device to indicate no bootable
device was found.
Any of the drives can be listed as a boot drive.
rd
♦
Boot 3
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
th
♦
Boot 4
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
th
♦
Boot 5
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
th
♦
Boot 6
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
NOTE
The default Boot order is, A, C, D, CD-ROM, and the BIOS will start its search for a
bootable device in drive A, then C, then D, then CD-ROM. If no bootable device is
found, the screen will display "No Bootable Device Available" and the boot process will
stop, allowing you to select from:
R – for Reboot, or
S – for Setup.
If you do not choose R or S, the boot process stops, until you intervene, unless you have
set [Reboot] as an option.
LittleBoard 700
Reference Manual
BIOS Setup
63
Advertisement
Table of Contents
