Lcd Brightness; Pair/Unpair Cam; Pair New Cam - VTech Safe & Sound User Manual

Parent unit settings

LCD brightness

You can change the brightness of the parent unit screen from Level 1
to Level 5. The LCD brightness is preset to Level 3.
To set the brightness of the parent unit screen:
Press MENU/
1.
SELECT
2. Press or
3. Press or
/SELECT to confirm your selection. You hear a confirmation tone.
4. Press
MENU

Pair/unpair CAM

Pair new CAM

The baby units and parent unit provided are already paired. You
can add or replace baby units (VM301, purchased separately) to
your video and audio monitor system.
You can pair a maximum of four baby units to your parent unit.
Each new baby unit must be paired to the parent unit before use.
Make sure you power on the baby unit (see page 29) and the parent unit
(see page 30) before pairing.
To pair a baby unit:
On the idle parent unit, press MENU/
1.
2. Press or
3. Press or
If you choose an occupied baby unit slot, the new baby unit will replace
the existing baby unit.
4. Make sure the new baby unit is turned on. On the new baby unit,
immediately press and hold + and - for 5 seconds when the parent unit
screen displays Please press both [+] and [-] keys on CAM side until
POWER indicator flashes Red and Green light. The
baby unit flashes red and green alternately.
5. When pairing is successful, the screen displays the image from the newly
paired baby unit. The
powered by AA batteries or turns green when it is powered by AC power.
• If pairing fails, the screen displays Pairing failed. Try the pairing
process again.
• Only one baby unit can be paired at a time.
when the parent unit is not in use.
to choose LCD BRIGHTNESS, then press
to choose the desired brightness.
to choose PAIR CAM, then press
to choose a desired baby unit slot, then press
light on the new baby unit turns red when it is
.
SELECT
MENU
27
/SELECT or
MENU
/SELECT or
.
/SELECT.
MENU
light on the new
.