VTech Safe & Sound User Manual page 41

Appendix
Troubleshooting (continued)
The parent unit plays any sounds from the baby unit and I think it is
too noisy.
You may have set the sensitivity level to Level 5 (Maximum). If you do so, the baby
•
unit will transmit any sounds detected to the parent unit. You may need to adjust the
sensitivity level to a lower level (page 23).
• You may need to adjust the speaker volume on the parent unit (page 30).
The parent unit does not play any sound when there is noise from the
baby unit.
• Make sure the parent unit is powered up by connecting it to AC power
the rechargeable battery provided (page 10).
• Make sure the parent unit is turned on (page 30) and the
off (page 30).
• Make sure the parent unit is not monitoring in multi-CAM mode.
• The parent unit may be too far away from the baby unit. Move the parent unit closer to
the baby unit (but not less than 3 feet).
• If the parent unit is powered by the provided battery, make sure there is sufficient
charge. Charge the battery in the parent unit for up to 12 hours.
• You may have set the sensitivity level to a very low level. If you do so, the baby unit will
not detect sounds that is too soft or light. You may need to adjust the sensitivity level to
a higher level (page 23).
• Large obstructions may impact the reception. Try to relocate the baby unit, away from
large obstructions such as walls and doors.
• Remove the battery and then install it again. Turn on the baby unit and the parent unit.
Allow up to one minute for the parent
• Other electronic products may cause interference with your video and audio monitor.
Try installing your video and audio monitor as far away from these electronic devices
as possible: wireless routers, radios, cellular telephones, intercoms, room monitors,
televisions, personal computers, kitchen appliances and cordless telephones.
Battery low at the Parent Unit and
• Charge the battery in the parent unit for up to 12 hours.
• Remove the battery and then install it again. Use it until fully depleted, then recharge it
in the parent unit for up to 12 hours.
• If the above measures do not correct the problem, replace the battery.
unit and the baby unit to synchronize. .
display on the parent unit.
35
(page 12)
speaker volume is not set to
or to