Parent Unit Battery - VTech Safe & Sound User Manual

Appendix

Parent unit battery

It takes up to 12 hours for the battery to be fully charged.
The standby time varies depending on the sensitivity level you set, your actual use
and the age of the battery.
The battery needs charging when:
• A new battery is installed in the parent unit.
• The parent unit beeps.
• The battery is properly installed and no battery icon displays on the screen.
• Battery low at Parent Unit and
• The light flashes on the parent unit.
CAUTION:
To reduce the risk of fire or injury, read and follow these instructions:
• Use only the battery provided or equivalent. To order a replacement, visit our website
at www.vtechcanada.com or call 1 (800) 267-7377.
• Do not dispose of the battery in a fire. Check with local waste management codes for
special disposal instructions.
• Do not open or mutilate the battery. Released electrolyte is corrosive and may cause
burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
• Exercise care in handling the battery in order not to create a short circuit with
conductive materials.
• Charge the battery provided with or identified for use with this product only in
accordance with the instructions and limitations specified in this manual.
• Observe proper polarity orientation between the battery and metallic contacts.
• To prevent fire or shock hazard, do not expose this product to water or any type
of moisture.
displays on the parent unit.
33