IOGear GCS1716 Installation Manual page 42

SET ACCES- This function allows the administrator to define user access to the computers on the
SIBLE PORTS installation on a port-by-port basis. For each user, select the target port; then press the
[Spacebar] to cycle through the choices: F (full access), V (view only), or blank. Repeat until
all access rights have been set then press [Enter]. The default is F for all users on all ports.
Note:
•
•
SET LOGOUT If there is no input from the console for the amount of time set with this function, the user is
TIMEOUT automatically logged out. A login is necessary before the console can be used again.
This enables other users to gain access to the computers when the original user is no lon-
ger accessing them, but has forgotten to log out. To set the timeout value, key in a number
from 1–180 minutes, then press [Enter]. The default setting of 0 disables this function.
A blank setting means that no access rights are granted. The port will not show up on
the user's LIST on the main screen.
The administrator always has full access to all ports.
42