Hardware Setup - IOGear GCS1716 Installation Manual

Hardware Setup

Overview
The GCS1716 is a combo switch designed to work with USB and PS/2 interfaces. It utilizes custom
KVM cables that serve as intermediaries between the switch and the connected computers. A separate
custom KVM cable is required for each computer connection. Custom cables of various lengths are listed
in the Cables section on page 5. Consult your dealer to find out which one fit your needs best.
Before You Begin
Make sure that the power to any device that you connect has been turned off. You must unplug the
power cords of any computers that have the Keyboard Power On function.
Stacking and Rack Mounting
The GCS1716 can be stacked on a desktop or rack mounted by a variety of different methods in 1U of
rack space. The procedures for each method are described in the following sections.
Note:
1. Allow at least 2 in (5.1 cm) on each side for adequate ventilation and 5 in (12.7 cm) at the rear for
power cord and cable clearance.
2. The standard rack mounting kit does not include screws or cage nuts. If you need additional screws or
cage nuts, contact your rack dealer.
15